Table of Contents
Advertisement
6.24
Changing the steering head bearing
Main work
-
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear
ing.
If there is detectable play:
-
Adjust steering head bearing play.
-
Move the handlebar to and fro over the entire steering range.
H01167-01
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
If detent positions are detected:
-
Adjust steering head bearing play.
-
Check the steering head bearing and adjust if neces-
sary.
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
-
Remove the front wheel.
-
Remove the fork legs.
-
Remove the start number plate.
-
Remove front fender.
-
Remove the lower triple clamp.
Main work
-
Remove lower bearing ring
Tool bracket (58429089000)
Pressing tool (58429092000)
-
Press the new bearing ring up to the stop with special
tool (D.
Tool bracket (58429089000)
Pressing tool (58429091000)
FORK, TRIPLE CLAMP 6
(a
p. 44)
(a
p. 44)
(a
p. 12)
(a
p. 12)
(a
p. 120)
(a
p. 18)
(a
p. 115)
(a
p. 114)
(a
p. 39)
O
8.
with special tool
(a
p. 297)
(a
p. 298)
(a
p. 297)
(a
p. 297)
43
Advertisement
Table of Contents
