16 BRAKE SYSTEM
156
8.
-
Mount bleeder cover
I Bleeder cover (00029013006)
-
Connect the bleeding device.
I Bleeding device (00029013100)
8.
-
Open shut-off valve
•
Info
I
Follow the instructions in the Owner's Manual of the
bleeding device.
-
Ensure that the inflation pressure is set on pressure
6l.
gauge
Correct the inflation pressure on pressure
regulator G) if necessary.
Guideline
I Inflation pressure
C,
-
Pull off protection cap
bleeder bottle hose.
I Bleeding device (00029013100)
0
Open bleeder screw
•
Info
I
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
@).
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
•
Info
I
Overfilling the brake fluid reservoir is prevented.
-
Tighten the bleeder screw. Remove the bleeder bottle hose.
Attach the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
-
Stand the vehicle upright.
-
Correct the brake fluid to marking
I Brake fluid DOT 4 / DOT 5.1
-
Mount and tighten the screw cap with the membrane and 0-
ring.
•
Info
I
Clean up overflowed or spilled brake fluid immediately
with water.
(8
p. 294)
(0
p. 294)
I 2 ... 2.5 bar (29 ... 36 psi)
of the bleeder screw. Connect the
(0
p. 294)
by approx. one half turn.
(!).
(8
p. 290)