Husqvarna FS 450 2017 Repair Manual page 38

6 FORK, TRIPLE CLAMP
36
-
Tighten air cartridge
Guideline
Damper cartridge
on outer tube
I
Ring wrench (T14017)
Right fork leg
-
Clamp the inside fork tube using the axle clamp.
Guideline I
-8
Use soft jaws.
-
Mount the special tool.
I
-8
Protecting sleeve (T1401)
-
Grease and push on dust boot
I
202103-10
Lubricant (T14034)
✓ The sealing lip is mounted with the spring expander
facing down.
Info
Always change the dust boot, seal ring, lock ring,
and support ring.
-
Push on lock ring
-
Grease and push on seal ring
I
Lubricant (T14034)
✓ The sealing lip points downward, the open side
upward.
-
Remove the special tool.
-
Push on support ring
-
Sand the edges of the slide bearings with 600 grit sand-
paper; then clean and grease the bearings.
I
Fork oil (SAE 4) (48601166S1)
-
Slide on lower slide bearing
-
Mount upper slide bearing (D.
Info
Without using a tool, pull the stack slightly apart
by hand.
@).
M51x1 .5 50 Nm (36.9 lbf ft)
(ral p. 310)
(0 p. 310)
O.
(ral p. 292)
8.
8.
(ral p. 292)
C,.
(0 p. 291)
0.