Wiring To The Head Module; Wiring - Mitsubishi Electric MELSEC L Series User Manual

6.5
This section describes the wiring to the head module.
6.5.1
This section describes how to connect an Ethernet cable to the head module and wiring precautions. For network
configuration and cables/hubs required for wiring, refer to the following.
User's manual for the master/local module used
(1) Connecting an Ethernet cable
(a) Connecting procedure
Downloaded from ManualsNet.com

Wiring to the Head Module

Wiring

L ER
P1
LINK
search engine
CHAPTER 6 INSTALLATION AND WIRING
1.
Power off both the head module and the device to
be connected.
2.
Push the Ethernet cable connector into the head
module until it clicks. Pay attention to the
connector's direction.
3.
Power on the head module.
4.
Power on the external device connected to PORT1
or PORT2 of the head module.
5.
Check that the LINK LED of the port where the
Ethernet cable is connected is on.
The time between the power-on and the LINK LED
turning on may vary. The LINK LED usually turns on in a
few seconds. Note, however, that the time may be
extended further depending on the status of the device
on the line if the link-up processing is repeated.
If the LINK LED does not turn on, refer to the following
and take actions. ( Page 91, Section 11.4)
47
6