6.5
Wiring to the Head Module
This section describes the wiring to the head module.
6.5.1
Wiring
This section describes SSCNET III cable wiring and precautions. For network configuration and cables for wiring, refer
to the following.
User's manual for the Motion controller used
(1) Connecting an SSCNET III cable
(a) Connecting the cable
Knob
46
1.
Power off the target device to be connected and the
head module.
2.
Connect an SSCNET III cable, which is to be
connected to the Motion controller, the first axis, or
the preceding station, to CNA.
Connect the SSCNET III cable to CNA holding the knob
of the cable connector. Securely insert the cable until it
clicks.
3.
Connect an SSCNET III cable, which is to be
connected to the second axis or the following
station, to CNB.
4.
Power on the head module.
5.
Power on the external devices connected to CNA
and CNB of the head module.