Ieee 802.11B (Wireless Lan) Configuration - Ricoh C7528 Setup Manual

Configuration

IEEE 802.11b (Wireless LAN) Configuration

Configure the printer to use IEEE 802.11b (Wireless LAN). The following table
shows the control panel settings and their default values. These items appear in
the [Host Interface] menu.
Setting Name
Comm. Mode
Channel
Trans. Speed
SSID
WEP Setting
❒ To use IEEE 802.11b (Wireless LAN), select [IEEE 802.11b] for [LAN Type] in
[Network Setup] in the [Host Interface] menu, and then set [IP Address], [Subnet
Mask], [Gateway Address], [DHCP], [Frame Type (NW)] and [Active Protocol] under
the [Network Setup] menu. For details about setting items under "Configuring
the Printer for the Network", see Software Guide.
❒ The IEEE 802.11b interface unit cannot be used simultaneously with a stan-
dard ethernet interface.
❒ In the [SSID] menu, if blank is specified in 802.11b Ad hoc mode or Ad hoc
mode, [ASSID] appears.
❒ Configure the WEP and SSID settings using the following procedure:
A
Press the {Menu} key.
The [Menu] screen appears on the display.
Default Value
802.11 Ad hoc
Inch version:
(1-11) 11
Metric version:
(1-13) 13
Auto
blank (ASSID)
Not Active
128