Table of Contents
Advertisement
Installing Options
E
Hang the auxiliary bar on the far left end, as shown, and then install the
stopper removed in step
Make sure the auxiliary bar and stopper are installed in the positions, as
shown.
F
Slowly raise the duplex reversal unit, and then fold it up to the printer.
G
Remove the adhesive tape holdings the cable, and then connect the ca-
ble from the duplex reversal unit to the upper connector on the back of
the printer.
This completes installation of the duplex reversal unit. Install the duplex feed
unit after the external tray.
B
.
110
Advertisement
Table of Contents
