Host Interface - Ricoh C7528 Setup Manual

Configuration
The [Menu] screen appears on the display.
B
Press the {U} or {T} key to display [Host Interface] menu, and then press
the {# Enter} key.
Menu:

Host Interface

The interface setting menu appears.
C
Press the {U} or {T} key to display [Network Setup], and then press the {#
Enter} key.
The network setup menu appears.
D
Press the {U} or {T} key to display [Active Protocol], and then press the
{# Enter} key.
E
Press the {U} or {T} key to select Active Protocol, and then press the
{# Enter} key.
Active Protocol:
TCP/IP
The following example explains activating TCP/IP.
The [Active] or [Not Active] selection screen appears.
F
Press the {U} or {T} key to select [Active] or [Not Active], and then press
the {# Enter} key.
TCP/IP:
*Active
After the settings are made, about two seconds later, the screen returns to the
active protocol menu.
G
Set other protocols you need to set in the same way.
H
Press the {Escape} key, the screen returns to the network setup menu.
❒ The default is "Active".
❒ Leave unused protocols "Not Active".
❒ Enable TCP/IP to use the Pure IP environment of NetWare 5/5.1, NetWare
6/6.5.
I
If you use TCP/IP, assign the IP address to the printer. Press the {U} or
{T} key to display [IP Address], and then press the {# Enter} key.
The current IP address appears on the display.
124