Table of Contents
Advertisement
Installing Options
E
Install the gigabit ethernet board, IEEE 802.11b interface unit, IEEE 1394
interface board, IEEE 1284 interface board, Bluetooth interface unit, or
USB host interface unit.
Install the gigabit ethernet board, IEEE 802.11b interface unit, IEEE 1394 in-
terface board, IEEE 1284 interface board, Bluetooth interface unit, or USB
host interface unit on the controller board.
The IEEE 1394 interface board and standard ethernet interface cannot be
used at the same time.
Only one of the following can be installed.
• Gigabit Ethernet Type 7300
• IEEE 802.11b Interface Unit Type H
• IEEE 1394 Interface Board Type B
• IEEE 1284 Interface Board Type A
• Bluetooth Interface Unit Type 3245
• USB Host Interface Unit Type 7300
F
Install the camera direct print card. (Camera direct print card Type 7300)
Insert the network data protection unit into the SD card slot on the controller
board.
G
Attach the duplex unit. (Duplex Unit Type 7100)
Attach the duplex reversal unit to the left side of the printer, and the duplex
feed unit inside the printer.
H
Attach the 2 tray finisher or the booklet finisher. (SR950, SR960)
Attach the 2 tray finisher or the booklet finisher to the left side of the printer.
You cannot install the 2 tray finisher or the booklet finisher unless both the pa-
per feed unit and duplex unit options are installed.
To install a finisher, contact your service representative.
Installing Options
Install options in the positions shown in the illustration.
50
Advertisement
Table of Contents
