Table of Contents
Advertisement
Guide to the Printer
❖ Duplex Unit Standard Model Printer
1.
Vent and dustproof filter
This helps keep internal components from overheating. Do not block or obstruct the
vent. Malfunctions may occur due to overheating. Remove the vent to replace the in-
ternal dustproof filter.
2.
Connector board
Connect the main power cable, cables from options, etc. to the appropriate port on
this board.
3.
Duplex unit port
Connect the cable for the duplex reversal unit to this port.
❒ The cable is already connected if your machine is the duplex unit standard model
printer.
4.
2 tray finisher/Booklet finisher port
Connect the cable for the 2 tray finisher or the booklet finisher to this port.
5.
Power port
Connect the power cable to this port and the other end to the wall outlet.
6.
Duplex reversal unit
Open this, and then the upper left cover of the printer, when removing misfed paper
or when replacing the fusing unit.
7.
Duplex reversal unit open bottom
8.
External tray
Printed output is stacked here, print side up.
9.
Lifting handle
Pull up and hold the bar of this handle to lift the printer. Remove the paper guide be-
fore pulling up the bar.
17
Advertisement
Table of Contents
