Table of Contents
Advertisement
Requirements
Refer to the table below to prepare the required devices, equipment, and cables
to set up a CM1164A/CM1284 system.
Console
1 x DVI-D Single Link display
capable of the highest possible
resolution
1 x USB mouse
1 x USB keyboard
(Optional) Microphone and
speakers
Computers
Each computer
with the following:
1 x DVI port
1 x USB Type A port
(Optional) Audio ports
Cables
1 x KVM cable (Single Link DVI-
D, 2.0 channel audio, USB 2.0)
1 x IEC320 Power Cord
1 x Cat 5 cable with an RJ-45
connector for Daisy Chain
Control
1 x IR Extension cable (sold
separately)
Note:
1. Make sure the computers' operating systems are supported. For information, see
Operating Systems, page 6.
2. The quality of the display is affected by the quality of the computer's graphics card.
ATEN recommends using a high quality product.
CM1164A
1
must be equipped
2
Chapter 1. Introduction
CM1284
1 x HDMI cable
1 x USB mouse
1 x USB keyboard
(Optional) Microphone and
speakers
1
Each computer
must be equipped
with the following:
2
1 x HDMI port
1 x USB Type A port
(Optional) Audio ports
1 x KVM cable (HDMI, 2.0
channel audio, USB 2.0)
1 x IEC320 Power Cord
1 x Cat 5 cable with an RJ-45
connector for Daisy Chain
Control
1 x IR Extension cable (sold
separately)
5
Advertisement
Table of Contents
