Table of Contents
Advertisement
CM1164A Rear View
5
4
No.
Component
1
Daisy Chain Control
In / Out ports
(DCC port)
2
Console Ports
3
KVM Ports
4
Power Socket / Power
Switch
5
Grounding Terminal
6
IR Receiver
(Extension)
1
2
6
Use these ports to connect to another CM1164A's
DCC port to pass keyboard and mouse signals.
You can daisy chain up to four CM1164A units.
If the CM1164A is set up as a single station, you
can control the CM1164A by sending serial
commands through the DCC In port. For details,
see Chapter 6, RS-232 Operation.
The cables from your USB keyboard, USB mouse, DVI
console display, a USB peripheral, microphone and
speakers plug into this section.
Note: When both the front-panel and rear-panel audio
ports are used, the front panel takes priority.
The cables that link the CM1164A to your DVI-D
Single Link computers plug in here. Each group of
the DVI KVM ports is comprised of a microphone
jack, speaker jack, USB Type B port, and a DVI
Single Link connector.
You can upgrade the CM1164A's firmware from a
computer connected to the USB KVM Port 1.
Plug in the power cord to the power socket and use
the switch to power on the CM1164A.
The grounding wire (used to ground the unit) attaches
here.
This receives signals from the IR remote control
through an IR extension, which can be purchased
separately (see Optional Equipment, page 6).
Chapter 1. Introduction
3
Description
9
Advertisement
Table of Contents
