Table of Contents
Advertisement
TM
Multi-View KVMP
CM1284 Rear View
4
5
No.
Component
1
Daisy Chain Control
In / Out ports
(DCC port)
2
Console Ports
3
KVM Ports
4
Power Socket and
Power Switch
5
Grounding Terminal
6
IR Receiver
(Extension)
10
Switch User Manual
1
6
2
Use these ports to connect to another CM1284's
DCC port to pass keyboard and mouse signals.
You can daisy chain up to four CM1284 units.
If the CM1284 is set up as a single station, you
can control the CM1284 by sending serial
commands through the DCC In port. For details,
see Chapter 6, RS-232 Operation.
The cables from your USB keyboard, USB mouse,
HDMI console displays, a USB peripheral, microphone
and speakers plug into this section.
Note:
1. HDMI Port 1 supports multi-view modes; HDMI
Port 2 supports full-screen display only.
2. When both the front-panel and rear-panel audio
ports are used, the front panel takes priority.
The cables that link the CM1284 to your
computers plug in here. Each group of the KVM
ports is comprised of a microphone jack, speaker
jack, USB Type B port, and an HDMI connector.
You can upgrade the CM1284's firmware from a
computer connected to the USB KVM Port 1.
Plug in the power cord to the power socket and use
the switch to power on the CM1284.
The grounding wire (used to ground the unit) attaches
here.
This receives signals from the IR remote control
through an IR extension, which can be purchased
separately (see Optional Equipment, page 6).
3
Description
Advertisement
Table of Contents
