Table of Contents
Advertisement
[CHANNEL]
[KEY]
f The authentication method is fixed to WPA2-PSK and the encryption method is fixed to AES, and they cannot be changed.
f Consult your network administrator before you change the values from the factory default.
f If [KEY] is kept as the factory default value, information leak by a third party may occur. Be sure to change it from the factory default value.
f Since the DHCP server automatically starts up, set the DHCP setting of devices to be wirelessly connected to the projector to on and
connect them.
Setting [USER1]/[USER2]/[USER3]
1)
Press as to select [WIRELESS LAN].
2)
Press qw to select [USER1], [USER2], or [USER3].
3)
Press the <ENTER> button.
f The [WIRELESS LAN] ([USER1], [USER2], or [USER3]) screen (1/2) is displayed.
4)
Press as to select each item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
Note
f When you use a DHCP server, confirm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, default gateway, and DNS server address.
f Wired LAN and wireless LAN cannot be used in the same segment.
5)
Press as to select [NEXT], and press the <ENTER> button.
f The [WIRELESS LAN] ([USER1], [USER2], or [USER3]) screen (2/2) is displayed.
6)
Press as to select each item, and change the settings according to the operation instructions of the
menu.
[SSID]
[AUTHENTICATION]
Chapter 4 Settings — [NETWORK] menu
1
The same character string as SSID
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
Enter the IP address when not using a DHCP server.
Enter the subnet mask when not using a DHCP server.
Enter the default gateway address when not using a DHCP server.
Enter the primary DNS server address when not using a DHCP server.
Enter the secondary DNS server address when not using a DHCP server.
Enter the same string as the SSID registered to the access point.
Select the user authentication method used in the network to which the projector is connected.
[OPEN]
[SHARED]
[WPA-PSK]
[WPA2-PSK]
[WPA-EAP/WPA2-EAP]
[WPA-EAP]
[WPA2-EAP]
Select this item when the authentication method of the access point
is Open System.
Select this item when the authentication method of the access point
is Shared Key.
Select this item when the authentication method of the access point
is WPA-PSK.
Select this item when the authentication method of the access point
is WPA2-PSK.
Select this item when the authentication method of the access point
is WPA-EAP/WPA2-EAP.
Select this item when the authentication method of the access point
is WPA-EAP.
Select this item when the authentication method of the access point
is WPA2-EAP.
ENGLISH - 79
Advertisement
Table of Contents
