Table of Contents
Advertisement
rDo not use cell phone, television, or radio as much as possible close to the projector.
Cell phone, television, or radio is using radio wave with different bandwidth from the projector, so there is no effect
on the wireless LAN communication or the send/receive on these devices. However, noise may occur in the audio
or video due to the radio wave from the projector.
rRadio wave for wireless LAN communication does not go through the reinforcing
bars, metal, or concrete.
The projector can communicate through wall or floor made of wood or glass (excluding the glass with metal mesh
embedded), but it cannot communicate through wall or floor made of reinforcing bars, metal, or concrete.
rDo not use the projector as much as possible in a location where static electricity is
generated.
The communication via wireless LAN or wired LAN may be prone to disruption when the projector is used in a
location where static electricity or noise is generated.
There is a rare case that the LAN connection may not be established due to static electricity or noise. In such
case, turn off the power with the power button on the remote control or the power supply unit of the projector,
remove the source of problematic static electricity or noise, and turn the power of the projector back on.
rUsing the projector outside the country
It is forbidden to take the projector outside the country or region where you purchased it, so use it only in the
country or region where you purchased it. Also, note that depending on countries or regions, there are restrictions
on the channels and frequencies at which you can use the wireless LAN.
rAvailable wireless LAN channels
The channels (frequency range) that can be used differ according to the country or region.
Please use the wireless LAN feature in compliance with the laws of each country.
Country or region
IEEE802.11b/g/n
North America
IEEE802.11a/n
IEEE802.11b/g/n
Other countries
IEEE802.11a/n
*1 The passive scanning is performed by changing radio to the channel being scanned in each country.
rThis device is restricted to indoor use when operated in the 5.15 to 5.35 GHz
frequency range (Channels 36 to 64).
Art-Net
"Art-Net" is an Ethernet communication protocol based on the TCP/IP protocol.
By using the DMX controller and the application software, illumination and stage system can be controlled. Art-Net
is made based on DMX512 communication protocol.
Cautions on use
rTo get a good picture quality
f In order to view a beautiful image in higher contrast, prepare an appropriate environment. Draw curtains or
blinds over windows and turn off any lights near the projection surface to prevent outside light or light from
indoor lamps from shining onto the projection surface.
Chapter 1 Preparation — Precautions for use
Standard
1 to 11
36 / 40 / 44 / 48
52 / 56 / 60 / 64
100 / 104 / 108 / 112 / 116 / 132 / 136 / 140
149 / 153 / 157 / 161 / 165
Passive scanning
Passive scanning
Channels used
*1
*1
Frequency band
(Center frequency)
2.412 GHz - 2.462 GHz
5.180 GHz - 5.240 GHz
5.260 GHz - 5.320 GHz
5.500 GHz - 5.700 GHz
(except 5.600 GHz -
5.650 GHz)
5.745 GHz - 5.825 GHz
2.412 GHz - 2.472 GHz
5.180 GHz - 5.825 GHz
ENGLISH - 21
Advertisement
Table of Contents
