Table of Contents
Advertisement
Setting up
Installing the projector
This projector is used in combination with the optional Ceiling Kit or Floor Stand Kit.
r When installing on the ceiling
The optional Ceiling Kit is required to use the projector directly installed on a ceiling.
f Be sure to use the Ceiling Kit specified for this projector.
f For installation of the projector to a ceiling, refer to the Installation Instructions of the Ceiling Kit.
Attention
f To ensure projector performance and security, be sure to ask your dealer or a building electrician for installing the projector to the ceiling.
r When standing on the floor
The optional Floor Stand Kit is required to use the projector set on the floor.
f Be sure to use the Floor Stand Kit specified for this projector.
f For installation of the Floor Stand Kit to the projector, refer to the Operating Instructions of the Floor Stand Kit.
f After installing the Floor Stand Kit, install the projector referencing "Projection dimensions" (x page 34).
Adjusting the projection position
Adjust the orientation of the main unit to adjust the projection position after installing the projector.
1)
Loosen the fixing screws.
f Loosen the rotating fixing screw and ball joint fixing screws (2 locations) using the supplied Allen wrench
(opposite side size 3.0 mm (1/8")).
Ball joint fixing screws
36 - ENGLISH
Chapter 2 Getting Started — Setting up
Pole
Rotating fixing screw
Advertisement
Table of Contents
