Table of Contents
Advertisement
[USER1]/[USER2]/[USER3]
Setting for computer
1)
Turn on the computer.
2)
Configure network settings following the instructions of your network administrator.
f If [M-DIRECT] is set on the projector side, set "Obtain an IP address automatically" in the network setting
on the computer side.
f If [USER1] through [USER3] are set on the projector side, follow the instructions of your network
administrator and configure each network setting item of your computer and the projector.
3)
Connect the computer to the network set for the projector.
f For Windows computers, click
on the projector, select the same name as SSID set for the projector. If [USER1] through [USER3] are set
on the projector, select the same name as SSID of your access point.
For Mac, click
projector, select the same name as SSID set for the projector. If [USER1] through [USER3] are set on the
projector, select the same name as SSID of your access point.
f If the projector is in the default settings and [M-DIRECT] is set, [SSID] is [M-DIRECTxxxx] (xxxx stands for
the last four-digit number of the network ID).
Note
f If you use wireless LAN connection utility that is standard for your OS, follow the operation procedure of the utility you use to connect to the
network.
104 - ENGLISH
Chapter 5 Operations — Network connection
[SSID]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[AUTHENTICATION]
[ENCRYPTION]
[DNS1]/[DNS2]
in the task tray (lower right of the computer screen). If [M-DIRECT] is set
in the menu bar (upper right of the computer screen). If [M-DIRECT] is set on the
Panasonic Projector
OFF
192.168.11.100
255.255.255.0
192.168.11.1
Open
None
None
Advertisement
Table of Contents
