Table of Contents
Advertisement
Before the installation
This section describes the display method using the projector.
Projection mode
The projection mode of the projector can be switched to the lighting mode to use the projector as a spot light, or to
the projector mode to project an image by pressing the <LIGHTING/PROJECTOR> button on the remote control.
(x page 47)
Installation method
The projector can be installed in two methods of ceiling mount and floor standing depending on the combination of
the optional accessories. Purchase the optional accessories depending on the installation method. The Ceiling Kit
(Model No.: ET-JPC100WE, ET-JPC100BE) is required for ceiling mounting installation, and the Floor Stand Kit
(Model No.: ET-JPF100WE, ET-JPF100BE) is required for floor standing installation.
Installation example when installing on
Installation form
There are total of four installation forms: two for the projection method and two for the display direction, for
each of two installation methods, when using the projector in the projector mode. Set the [SETUP] menu →
[PROJECTION METHOD] (x page 68) and [VERTICAL FLIP] (x page 68) depending on the installation
form in combination with the optional accessories.
Chapter 2 Getting Started — Before the installation
Lighting mode (example)
the ceiling
A B C
Projector mode (example)
Installation example when standing on the
floor
ENGLISH - 31
Advertisement
Table of Contents
