Table of Contents
Advertisement
Turning on/off the projector
Power indicator
Indicates the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before
operating the projector.
When the light source indicator <LIGHT> and the temperature indicator <TEMP> are lighting or blinking, a
problem may have occurred inside the projector. Check the status of the indicator before turning on the projector,
and take appropriate steps. (x page 200)
Indicator status
Off
Red
Green
*1 The indicator will blink in frequency of lighting 2.75 seconds → off 0.25 seconds → lighting 0.75 seconds → off 0.25 seconds.
*2 The indicator will blink in frequency of lighting 2.75 seconds → off 0.25 seconds.
Note
f The projector consumes power even in standby mode (when the power indicator <ON (G)/STANDBY (R)> is lighting or blinking in red).
Refer to "Power consumption" (x page 213) for the power consumption.
f The power indicator <ON (G)/STANDBY (R)> blinks in green if a remote control signal is received.
f The power indicator <ON (G)/STANDBY (R)> blinks slowly in green while the AV mute is in use.
f When the computer (including iPad/iPhone/iPod touch, Android terminals) performs a connection check on the projector using the
Panasonic image transfer application software, the power indicator <ON (G)/STANDBY (R)> blinks in orange.
Chapter 3 Basic Operations — Turning on/off the projector
The power is not supplied to the projector. (The power supply to the interior wiring is
turned off or the power cord is not connected to the outlet.)
The power is switched off. (standby mode)
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to [ECO].
Lighting
Projection will start when the power <v/b> button is pressed.
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 200)
The power is switched off (in standby mode).
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to
[NETWORK].
Blinking
*1
Projection will start when the power <v/b> button is pressed.
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 200)
The power is switched off (in standby mode).
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to [NORMAL].
Blinking
Projection will start when the power <v/b> button is pressed.
*2
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 200)
Lighting
Projecting.
Power indicator <ON (G)/STANDBY (R)>
ON(G)/
STANDBY(R)
LIGHT
Light source indicator <LIGHT>
TEMP
SD
Temperature indicator <TEMP>
Projector status
ENGLISH - 41
Advertisement
Table of Contents
