Table of Contents
Advertisement
f For some items, press qw to display an individual adjustment screen with a bar scale as shown below.
Note
f Pressing the <RETURN> or <MENU> button on the remote control while the menu screen is displayed returns the screen to the upper
hierarchical menu.
f In the projector mode, the [MAIN MENU (PROJECTOR)] screen is displayed as the menu screen. In the lighting mode, the [MAIN MENU
(LIGHTING)] screen is displayed as the menu screen. The main menu items and sub-menu items displayed on the menu screen differ
depending on the projection mode.
f Some items may not be allowed to adjust or use depending on the selected projection mode or signal input to the projector. The menu items
that cannot be adjusted or used are shown in gray characters, and they cannot be selected.
f Some items can be adjusted even if signals are not input.
f Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.
f For menu items, refer to "Main menu" (x page 56) and "Sub-menu" (x page 57).
Resetting the adjusted value to the factory default
If the <DEFAULT> button on the remote control is pressed, the values adjusted in the menu items are restored to
the factory default settings.
button
1)
Press the <DEFAULT> button on the remote control.
Note
f You cannot reset all the settings to the factory default at a time.
f To reset all the adjusted sub-menu items to the factory defaults at a time, perform the [SETUP] menu → [INITIALIZE] (x page 76).
f Some items cannot be reset to the factory default settings even when the <DEFAULT> button on the remote control is pressed. Adjust those
items individually.
f The square mark under the bar scale in the individual adjustment screen indicates the factory default value. The position of the square mark
varies by the input signal.
Setting the on-screen display to show/hide
If you hold down the <MENU> button on the remote control for at least three seconds, the on-screen setup screen
appears and the on-screen display can be set to show/hide.
Main menu
The following nine items are included in the main menu. When a main menu item is selected, the screen changes
to a sub-menu selection screen.
The main menu items displayed on the menu screen differ depending on the projection mode. When the
projection mode is set to the projector mode, the [LIGHTING] menu is not displayed. Press the <LIGHTING/
PROJECTOR> button on the remote control and switch to the lighting mode before starting operation.
(x page 51)
[LIGHTING]
[PICTURE]
[MEMORY VIEWER]
56 - ENGLISH
Chapter 4 Settings — Menu navigation
CONTRAST
ADJUST
CONTRAST
ADJUST
Current adjustment value
Factory default setting
Main menu item
*1
*2
*2
0
0
Page
60
63
66
Advertisement
Table of Contents
