Table of Contents
Advertisement
About your projector
Remote control
1
Remote control signal transmitter
2
Power <v/b> button
Turns on/off the power of the projector. (x page 41)
3
<Miracast> button
Switches the input to Miracast. (x page 47)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Miracast.
4
<SIGNAGE> button
Switches the input to signage. (x page 47)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
signage.
5
<MEMORY VIEWER> button
Switches the input to Memory Viewer. (x page 47)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Memory Viewer.
6
asqw buttons/<ENTER> button/<RETURN> button
Used to operate the menu screen. Also used when entering
[SECURITY PASSWORD].
7
<AV MUTE> button
Used to turn off the image and audio temporarily. (x page 52)
8
<DEFAULT> button
Resets the settings of the sub-menu to the factory defaults.
(x page 56)
9
<MENU> button
Displays the main menu. (x page 55)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
Chapter 1 Preparation — About your projector
1
3
2
4
5
6
7
8
9
10
11
12
13
14
15
16
17
10 <ZOOM> button/<FOCUS> button
Displays the lens menu and adjusts the projection lens.
(x page 48)
11 <VOL+>/<VOL-> buttons
Adjusts the volume of audio output. (x page 52)
12 <LIGHTING/PROJECTOR> button
Switches the projection mode of the projector to lighting mode
or projector mode. (x page 47)
13 <Panasonic APP> button
Switches the input to Panasonic APPLICATION. (x page 47)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
Panasonic APPLICATION.
14 <HDMI> button
Switches the input to HDMI. (x page 47)
When you press this button during the lighting mode, the mode
is switched to the projector mode, and the input is switched to
HDMI.
15 <ID ALL> button
Used to simultaneously control all the projectors with a
single remote control in a multiple projector environment.
(x page 28)
16 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 28)
17 Number (<1> - <6>) buttons
Used in a multiple projector environment.
Used to enter ID number or password.
ENGLISH - 25
Advertisement
Table of Contents
