r When using the optional Floor Stand Kit
1)
Press the power <v/b> button.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2)
Press qw on the remote control to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button again.)
f The projection is finished.
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> lights in red.
4)
Disconnect the plug of the power cord from the outlet
Note
f The projector will continue to consume power when the power is supplied to the projector even if the power is turned off by
pressing the power <v/b> button.
The power consumption during standby can be conserved when the [SETUP] menu → [STANDBY MODE] is set to [ECO].
f The projector can be turned off by turning off the power supply of the interior wiring or disconnecting the plug of the power cord from the
outlet during the projection, but the settings and adjustments performed right before turning off the power may not be reflected.
f Do not turn off the power supply of the interior wiring, disconnect the plug of the power cord from the outlet, or eject the SD card while the
SD card indicator <SD> is blinking. The projector may not operate properly or the contents of the SD card may get damaged.
f When the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], the internal cooling fan may operate even
during standby.
46 - ENGLISH
Chapter 3 Basic Operations — Turning on/off the projector