Setup Screen Unavailable On Web Browser; When The Ap Will Not Start - Contec FXE3000 Series User Manual

7. Troubleshooting
- Sometimes communication is hindered by attenuation of electric waves. Attenuation occurs
naturally as distance from the source of transmission increases, but may also be caused by objects in
the path of the transmission. The objects primarily responsible for attenuation are the following.
- Concrete walls
- Metallic surfaces around this product

Setup Screen Unavailable on Web Browser

- Check if communication is possible between the product and PC.
- If no problem is detected in the communication between the product and PC, it may be related to the
browser settings. For the browser settings, see Chapter 3 "Connection to Devices and Setup
Methods".

When the AP Will Not Start

Check the LED
- Check whether the "POWER" LED is illuminated. If it is not illuminated, check the power cable
and make sure that it is connected correctly to the power jack and the socket.
- Check whether the Power LED is flashing. If the power LED is still flashing more than 5 minutes
after the power is switched on, the problem may be an AP firmware failure.
In this case, the problem may be a startup error caused by corrupt data in the memory of this product.
If you cannot restore it, contact your retailer.
Check the power
- If using an AC adapter, check that the adapter is an optional accessory of a type specified by
CONTEC. Only use AC adapters specified by CONTEC with this product.
- If supplying power from the power connector, check the power supply connection, supply voltage,
etc., and make sure that there are no problems. For details about connecting the power supply, see
Chapter 2 "Setup".
- When you are supplying power from the LAN connector, check that the cable is securely connected
to the devices being used and that the cable category is appropriate.
* This product does not support the IEEE802.1af and IEEE802.1at standards.
84
FXE3000 Series