Maintenance - Contec FXE3000 Series User Manual

4. Setup and Status Display

Maintenance

Firmware Update
You can update the firmware on the device.
Click the "Browse" button, select the version update file system file, and then click the "Update" to
upload the file to the device. The file is uploaded and the update task finishes about one to one and a half
minutes after clicking the "Update" button, then the page changes. After uploading the file finishes, the
device starts with the overwritten firmware by restarting.
When the version update fails, check that the uploaded file is the correct file, and then try to update the
version again.
Do not turn off the device's power under any circumstances during the updating task from when the
"Update" button is clicked until the screen changes as this will result in malfunction.
The progress bar displayed during the update is a guide that indicates the progress status in terms of time,
it does not indicate the actual progress of the work. The progress bar indicates the completion time when
the gauge is full.
Do not turn off the device's power while the firmware is being uploaded until the screen changes.
Time Adjustment
Set the date and the time for the device. Enter the year as four digits, the month, the day, the hour (24-
hour time), the minute, and the seconds, and then click the update button. When the month and day are a
single digit, a 0 is added and they are displayed as two digits. You can enter the values as either a single
digit or as two digits. (Example: 2015/1/1 0:0:0) Or click the "Set PC Time" button to set the time in the
PC's internal clock where the browser is open in the entry form.
Password
You can change the login password to this device including the Wireless LAN Manager (this
configuration web page). Enter the password as alphanumeric characters with a maximum length of 32
characters. The changed password is valid after the device restarts.
61
FXE3000 Series