Vap - Contec FXE3000 Series User Manual

4. Setup and Status Display

VAP

TX Rate
Set the transmission rate for wireless networking for the device.
This setting is normally set to "Auto". To lock the transmission rate, select "Lock" and select the locked
transmission rate.
Default setting : Auto
Maximum TX Rate
When the transmission rate is "Auto", set the upper limit for the transmission rate.
This setting is normally set to "Disable". To lock the maximum transmission rate, select "Lock" and
specify the rate. The device can automatically select and communicate at a rate that does not exceed the
specified rate.
Some rates cannot be set as the maximum transmission rate due to the wireless LAN standard. Those
rates are not shown in the drop-down list.
Default setting : Disable
Link Down Detection
This function monitors the wired networking port and stops the wireless function when the wired
networking port link is down (when disconnected). To use this function, set to "Enable".
If the unit type is set to "Station", use caution when using this function because the wireless network
cannot be accessed when the wired networking port is down.
This setting is not available when the unit type is set to "Repeater". It is forcibly set to disabled.
Default setting : Disable
39
FXE3000 Series