2. Setup
The antenna must be mounted and installed properly before configuring this product. Follow the setup
procedure for the product shown below.
Component Locations
WLAN
POWER
LED display
LED name
POWER
LAN
WLAN
POWER/ LAN/ WLAN
POWER/LAN
DIP switches
No. Name
1
INIT
Turning on this switch flashes the POWER,
WLAN LEDs. If the switch is turned off
before the LEDs change their status from
flashing to ON (about 3 seconds), all the
settings are restored to the default settings
after the product is started next time.
Reboot the product after the LEDs stop
flashing. *1
2
-
FXE3000 Series
LAN
Status
ON
Flashing
OFF
ON
Flashing
OFF
ON
Flashing
OFF
Flashing (simultaneously) Indicates that a file is being written.
Blinking twice / On
Operation / function
(1)
(2) (3)
(1)
LAN port
(3)
DC JACK
(5)
DIP Switches
Indicates that the device is operating.
Indicates that the device is being started (This device turned on)
Indicates that the device is power off.
Indicates that a wired LAN has been connected.
Indicates that the product is transmitting/receiving data to/from the
connected terminal through wired LAN.
Indicates that a wired LAN has been no connected
Indicates that the device has been connected.
Indicates data is being transmitted to or received from the device
connected through wireless LAN.
Indicates that the device has been no connected.
DHCP error
INIT connector
No. Name
1
INIT
Short the INIT signal with the GND so that
the POWER, WLAN, and LAN LEDs will
flash. Then if you open the INIT signal
before the LEDs turn on (approx. 3 seconds),
the settings are restored to the default
settings the next time the product is started.
2
GND
GND
(5)(6)
(4)
POWER
WLAN
(2)
Power connector
(4)
INIT connector
(6)
DIP LED
Indicator
Operation / function
2. Setup
11