Connection To Devices And Setup Methods; Preparation Before Setup - Contec FXE3000 Series User Manual

3. Connection to Devices and Setup
Methods
This product is set up via a network using a Web browser. Follow the setup procedure below once the
product is set up.

Preparation before Setup

You must use a PC which can be connected to a network as the product is set up via the network.
The setup is performed by connecting a PC for setup purposes and then using a Web browser.
Connecting for the first time
(1) Connect this product to PC on a wired LAN.
(2) Select an IP address 192.168.0.XXX (e.g. 192.168.0.10) for the PC, which is not the same address as
for this product. And then set the subnet mask to 255.255.255.0
* The default setting IP address is 192.168.0.1.
The following example settings are for Windows 8, Windows8.1, Windows 7, or Windows Vista using
Internet Explorer 11.0.
Windows 8 / Windows 8.1
(1) Right-click the Windows logo icon, and then click [Control Panel], [Network and Internet],
[Network and Sharing Center], then [Change adapter settings]. Then, right-click the Ethernet icon,
and then click [Properties].
(2) If a User Account Control window appears, click "Yes" or "Continue".
(3) Select the "Internet Protocol Version 4 (TCP/IPv4)" check box, and click "Properties".
(4) In the "Use the following IP address" field, type an IP address 192.168.0.XXX, which is not the
same address as this product (e.g. 192.168.0.10), and then set the subnet mask to 255.255.255.0.
(5) Click "OK", and then click "OK" or "Close" to enable the settings.
FXE3000 Series

3. Connection to Devices and Setup Methods

17