Vap - Contec FXE3000 Series User Manual

4. Setup and Status Display

VAP

▼
VAP Settings
ESSID
Set the ESSID for the device as alphanumeric characters between 2 and 32 characters in length. The
ESSID for VAP1 must be set.
When the unit type is "Access Point", VAP2 through VAP4 (virtual AP) are enabled by configuring their
ESSIDs. When setting the ESSIDs for multiple VAPs, ensure that the ESSID values are not already in
use.
When the unit type is "Station", the VAP2 through VAP4 settings are not required.
When the unit type is "Repeater", set the ESSID for VAP1 and VAP2. Due to the characteristics of the
repeater, normally set the ESSID for VAP1 and VAP2 to the same setting.
Default setting : LocalGroup
▼
Encryption Settings
Encryption
Select the encryption to use with wireless networking. Further settings that must be configured are
displayed depending on the selected setting, so configure the displayed settings.
Default setting : Disable
CAUTION
WEP and TKIP cannot be used with IEEE 802.11n due to the rules of the standard. Note that when
the wireless networking standard is IEEE 802.11n and encryption is configured that uses those
settings, the device will operate with the legacy standards (IEEE 802.11a and IEEE 802.11g).
30
FXE3000 Series