Power Supply - Contec FXE3000 Series User Manual

Power Supply

Power Supply
Using the DC JACK
The power plug to be used must conform to EIAJ voltage classification 2.
CAUTION
When supplying power via the LAN connector, do not use a combination
of power supplied from the power connector and the AC adapter.
When supplying power, only use a single power supply method.
Using the Power connector
The power connector in Figure 1 can be used to supply
power from an external source. Use the following power
cable or its equivalent.
CAUTION
When supplying power from the power connector,
do not use a combination of power supplied via the
LAN connector and the AC adapter.
When supplying the LAN cable power
CAUTION
- Create the power cable correctly as specified. Using the power cable with the housing pins assigned
wrong numbers may result in device faults or accidents.
- The input voltage range of this product is from 5 to 24 VDC ±5%. Supply power outside that range
may result in device faults or accidents.
- Use the power supply whose supply voltage rises to at least 4.75VDC within the input voltage range
within 10ms. Using a power supply which does not satisfy this condition may result in device faults or
accidents.
- Input voltage range: 5 to 30 VDC ± 5%. Use a power supply that rises to 4.75 VDC or higher in the
input voltage range within 10 ms. There is a risk of damage to the device or accident if a power supply
outside this range is used.
FXE3000 Series
Power connector
Housing: JST S02B-PASK-2(LF)(SN)
Cable: AWG28-16(equivalent to it)
Pin No. Name Operation /
1 Vi+ 5-30VDC ± 5%
2 Vi-
2. Setup
Function
GND
13