Vlan - Contec FXE3000 Series User Manual

4. Setup and Status Display

VLAN

VLAN Function
To use the VLAN function, configure the settings. There are two types of VLAN: "Static VLAN" and
"Dynamic VLAN". To use the VLAN function, select the one to use.
For "Static VLAN", set the VLANID for each virtual AP (VAP).
"Dynamic VLAN" is a VLAN function that only passes packets with an attached VLANID tag configured
in the VLAN table.
When not using the VLAN function, set to "Disable".
Default setting : Disable
Local VLAN ID
Set the VLANID for the wired networking port on the device. Set this value between 1 to 4094.
Default setting : 1
Native VLAN ID
Set the native VLANID. Set this value between 1 to 4094.
When you wish to discard all packets without a VLAN tag, specify an appropriate VLANID that is
unused.
Default setting : 1
VAP VLAN ID
To use a static VLAN, set the VLANID assigned to the VAP (virtual AP).
Specify this value between 1 to 4094. When the device is a repeater, only the VLANID for VAP1
(repeater AP) can be configured. With a repeater, VAP1 (repeater AP) and VAP2 (repeater ST) operate
with the same VLANID.
Default setting : 1
48
FXE3000 Series