Log - Contec FXE3000 Series User Manual

4. Setup and Status Display

Log

Log Function
To record the log for the device using the log function, set to "Enable".
You can prevent the log from being recorded by setting this setting to "Disable", but in normal operation
this is unnecessary.
Default setting : Enable
Save Log
To save the recorded log information as a file, set to "Enable". To only temporarily retain the recorded log
information in memory, set to "Disable".
Temporary retention means the log information is retained only while the device is running. When
"Disable", the log information is deleted when the device restarts or the power is disconnected.
Default setting : Disable
Save Interval (min)
Set the interval at which to save the log.
Set this value between 5 and 1440 minutes.
Default setting : 60
SYSLOG Server
To send the acquired log information to a SYSLOG server as a SYSLOG, set the IP address for the
SYSLOG server.
When not sending the log information to a SYSLOG server, set to 0.0.0.0 to disable.
Default setting : 0.0.0.0
Debugging Log
Please set to "Enable" if you want to log for more detailed debugging.
You do not need to "Enable", usually.
Default setting : Enabled
50
FXE3000 Series