Table of Contents
Advertisement
4. Setup
Wall Installation
Using the Mounting Screws (Included)
Place the screws in the wall according to the mounting diagram,
then mount the unit.
It is also possible to remove the cover from the unit, then remove
the wireless card and screw the unit onto the wall directly.
Diagram 1
Diagram 2
(1)
Figure 4.1. Wall Installation
Note!
Do not obstruct the ventilation slits. This can cause the
temperature inside the product to rise and can damage the
components inside.
Caution!
Do not install this unit upside down. This will
cause heat to accumulate and possible cause fire.
(2)
(1)
(3)
(1) Place the screws in the wall according to the mounting diagram
(2 screws).
(2) Position the AP unit so that the two wall mount holes in the AP unit
fit over the two screws in the wall.
(3) Slide the AP unit down to hold it in place.
(2)
(1) Press here to open the lid.
(2) Slide the cover in the direction shown and release the
catch. Remove the wireless card.
(1)
(3) Insert the screw to attach the unit. After mounting,
replace the wireless card and cover.
FX-DS110-APL
Setup
(3)
17
Advertisement
Table of Contents
