Table of Contents
Advertisement
2. Setup
Pin header (JP2)
1
2
2
1
3
4
4
3
5
5
6
6
7
7
8
8
Name
No.
LAN port
The INIT (initialization) signal can be
1
4pin
connected to via pin 4 on the LAN port
by shorting pin 1 and pin 2.
2
INIT
LAN port
The GND can be connected to via pin 5
3
5pin
on the LAN port by shorting pin 3 and
pin 4
4
GND
LAN port
The power supply line can be connected
5
7pin
to via pin 7 on the LAN port by shorting
pin 5 and pin 6.
6
24VDC
LAN port
The GND can be connected to via pin 8
7
8pin
on the LAN port by shorting pin 7 and
pin 8.
8
GND
*1 When initializing the product by turning the INIT signal on and off, the LEDs will continue flashing for a short time
after the signal is turned off. This indicates the internal memory files are being deleted. If the power is turned off
while the LEDs are flashing, the internal memory files may be damaged and the product may no longer be able to
start properly. Always restart the product after the LEDs stop flashing.
CAUTION
-
If you set the short pin header (JP2), you will be able to supply power from the LAN connector.
However, setting the incorrect pin to short and turning on the product's power supply may lead to
device malfunctions or accidents.
-
When supplying power via the LAN connector, do not use a combination of power supplied from the
power connector and the AC adapter.
Checking the Network Addresses
The Ethernet (wired LAN), wireless LAN MAC address and IP address are defined on the housing sticker
on the side of this product. Write down the MAC addresses for Ethernet and wireless LAN in the
following table as they are device-individual values and may be required for future setup.
Table 2.1. Network Address
Description on the
housing sticker
IP:
LAN MAC:
WLAN MAC:
12
Operation / function
Explanation
Default IP Address
LAN MAC Address
Wireless LAN MAC
Address
LAN connector
Name
No.
Transmit (+)
1
TX+
Transmit (-)
2
TX-
Receive (+)
3
RX+
Short the INIT signal with the GND so
that the POWER, WLAN, and LAN LEDs
will flash. Then if you open the INIT signal
before the LEDs turn on (approx. 3
seconds), the settings are restored to the
4
INIT/NC
default settings the next time the product
is started.*1
* Usable when JP2 No. 1 and No. 2 are
connected.
5
GND
GND
6
RX-
Receive (-)
7
24VDC
Power Supply
8
GND
GND
192.168.0.1
Operation / function
Address
FXE3000 Series
Advertisement
Table of Contents
