Table of Contents
Advertisement
■ 1000Base-SX/LX SFP interfaces (Shared Port-23, Port-24, Port-47 and Port-48)
LED
Color
1000
Green
LNK
2.1.3 Switch Rear Panel
The rear panel of the Managed Switch indicates an AC inlet power socket, which accept input power from 100 to 240V AC,
50-60Hz.
Figure 2-5
shows the rear panel of these Managed Switch.
WGSW-48000 Rear Panel
■ Console Port
The console port is a DB9, RS-232 male seria port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users an run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the statup screen of the device.
■ AC Power Receptacle
For compatibility with electric service in most areas of the world, the Managed Switch's power supply automatically adjusts
to line power in the range 100-240VAC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptalbe on the rear panel of the Managed Switch. Plug the other
end of the power cord into an electric service outlet then the power will be ready.
The device is a power-required device, it means, it will not work till it is powered. If your networks should
active all the time, please consider using UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
Power Notice:
In some area, installing a surge suppression device may also help to protect your Managed Switch from
being damaged by unregulated surge or current to the Switch or the power adapter.
Lights: To indicate the link through that SFP port is successfully established with
speed 1000Mbps
Off:
To indicate that the SFP port is link down
Figure 2-5 Rear panel of WGSW-48000
Function
29
User's Manual of WGSW-48000
Advertisement
Table of Contents
