Table of Contents
Advertisement
4.5 QoS
4.5.1 IP Access Control List
An ACL consists of a set of rules which are matched sequentially against a packet. When a packet meets the match criteria of a
rule, the specified rule action (Permit/Deny) is taken and the additional rules are not checked for a match. On this menu the
interfaces to which an ACL applies must be specified, as well as whether it applies to inbound or outbound traffic. Rules for the
ACL are specified/created using the ACL Rule Configuration menu.
4.5.1.1 IP ACL Configuration
This page is to configure the access control list on ports.
Configurable Data
ACL - Make a selection from the pull-down menu. A new Access Control List may be created or the configuration
。
of an existing ACL can be updated.
ACL ID - ACL ID must be a whole number in the range of 1 to 99 for IP Standard Access Lists and 100-199 for IP
。
Extended Access Lists.
Slot.Port(s) - This dynamic multi-selector lists all available valid interfaces for ACL mapping. All non-routing
。
physical interfaces and interfaces participating in LAGs that are not already assigned to an ACL are listed. An
interface can be mapped to one and only one ACL, but multiple interfaces can be assigned to one ACL.
Direction - Select the packet filtering direction for the ACL from the pulldown menu.
。
Choices:
Inbound
The packet direction for a given ACL is the same for all affected interfaces.
Non-Configurable Data
Table - Displays the current and maximum number of ACLs.
。
Figure 4-5-1 IP ACL Configuration
172
User's Manual of WGS3-2820/WGS3-5220
Advertisement
Table of Contents
