waveform, adjust S post height. If the envelope drop appears on
the right-half of the waveform, adjust T post height.
CAUTION:
Do not apply excessive pressure onto the S and T Posts when
adjusting S and T post height.
Note:
It will be possible to confirm step 4) after performing the following
steps.
A. Exit the "I. Tracking Fix" mode, then skip the "J. PG Shifter"
mode to enter other modes (except these 2). Or, close the
service mode.
B. Press the Tracking Control Up or Down button on the
camcorder. Make sure that the envelope waveform remains flat.
If not, readjust S and/or T post heights.
5. After adjustment, confirm that the tape travels without curing at S
and T posts.
Fig. M3-1
Fig. M3-2
84