Advertisement
Quick Operation Guide
Charging the Battery Pack
Charge Battery Pack fully before operation.
2
Insert Battery.
CHARGE Lamp
lights and then goes
out when charging is
done.
Insert the CompactFlash Card
When the CompactFlash Card is not inserted in CAMERA or PHOTO mode,
appears on-screen. Be sure to insert the CompactFlash Card
before using the Built-in Digital Still Camera.
CAMERA recording is possible even when the CompactFlash Card is not inserted.
2
3
Insert the CompactFlash
Card.
Quick Operation Guide (continued)
Playback using the LCD
Monitor
When the LCD monitor is open, the EVF
automatically turns OFF.
1
Press LCD-OPEN to unlock the
LCD monitor. Swing it fully
open and adjust the angle.
2
Set POWER to VCR.
PHOTO
VCR
CAMERA
OFF
1
Plug in AC Adaptor.
Slide TAPE EJECT to open door.
1
Attach fully
charged Battery.
Before you begin...
Charge Battery Pack fully before operation.
3
Press REWIND/SEARCH
to rewind tape.
STILL
DEL
4
PLAY
Press PLAY to
start playback.
REW
FF
5
Press STOP to
STOP
stop playback.
Insert Cassette
2
Press here to close door.
Camera Recording
When the LCD monitor is open, the EVF automatically turns OFF.
1
Press LCD-OPEN to unlock the
LCD monitor. Swing it fully open
and adjust the angle.
Built-in Auto Light
Using the Light
For recording in dim lighting.
LIGHT
OFF AUTO
ON
x
1
12:00:00AM
JAN
1 2000
Replacing the Bulb
DANGER:
Use only replacement bulb (PART NO.
VLLW0015) supplied by Panasonic to
reduce risk of fire.
Handle new bulb with cloth or tissue as
skin oils will decrease bulb life.
Remove lens cover and allow bulb to
cool before replacing to avoid possible
burn hazard.
1
Insert cassette.
2
Set POWER to
CAMERA.
PHOTO
VCR
CAMERA
OFF
3
Press RECORD/PAUSE to start
recording.
Press RECORD/PAUSE again to
pause recording.
Before you begin...
Connect Camcorder to power source.
Set POWER to CAMERA.
Set LIGHT to AUTO.
Light turns on/off automatically according
to lighting conditions.
Or, set LIGHT to ON/OFF manually.
appears in EVF or LCD monitor when
Light is on.
SP
REC
Caution:
Light becomes hot. Never cover Light while
on.
Before you begin...
Order Part No. VULS0001 (VLLW0015 and
cushions) for replacement bulb unit.
Set POWER to OFF.
1
Press in on both sides of lens
cover and pull straight out and off.
2
Using Tweezers or needle-nose
pliers, carefully remove bulb.
Take unit to service center if you
need assistance.
3
Replace bulb using a clean cloth or
tissue.
4
Replace lens cover.
Note:
Using Light reduces battery operating time.
Provide proper ventilation when using Light
extensively in a hot environment.
Using Light when the Camcorder is powered
by a car battery may shorten bulb life.
Set Light to OFF when not in use.
Handle bulb gently. Excessive force may
cause bulb to crack.
Advertisement
