5.1.7. HOW TO REMOVE A JAMMED TAPE
CAUTION:
If loading does not start after DC Power Supply is applied, DO NOT
continue applying DC Power Supply.
5.1.7.1. Remove a jammed tape as follows:
1. Remove a Screw and remove the EVR Cover.
2. Place the unit with the Cassette Cover facing upward.
3. Slide the Lock Lever through TP Board slot to open the Cassette
Cover slightly. Then, slide the CF Card Connector Unit so that the
TP Board Kit can connect to Main C.B.A. (S301) as shown. (Hold
the Cassette Cover slightly downward.)
Note:
Fig. 3-2
Fig. 4-1
18