5.1.6. METHOD FOR LOADING/UNLOADING OF MECHANISM
5.1.6.1. (Electrical Method)
CAUTION:
If loading does not start after DC Power Supply is applied, DO NOT
continue to applying DC Power Supply.
Connect the TP Board Kit as shown, and apply 3 VDC Power Supply (DC+ to TP21, DC- to TP20
for loading or DC+ to TP20, DC- to TP21 for unloading). Refer to
It normally takes approx. 6 seconds to unload the Mechanism from fully-loaded position to
EJECT position.
5.1.6.2. (Manual Method) without Cabinet Parts
Turn the Gear of Reduction Gear Unit clockwise (for loading) or counterclockwise (for
unloading) manually.
It is necessary to rotate approx. 80 times from fully-loaded position to EJECT position.
"HOW TO USE TP BOARD
Fig. 3-1
17
KIT."