Advertisement
Playing Back Recordings (continued)
Special Effects
STILL
DEL
PLAY
UP
REW
FF
DOWN
MENU
DISPLAY
STOP
Note:
During search, horizontal noise bars will appear. Audio is muted.
To protect video heads and tape, operating modes will revert as follows after 5 minutes:
Still
Stand-by
Stand-by
Power off (when Battery Pack is used).
Tape auto-rewinds if played or fast forwarded to end.
Tracking Control
TV Tuner
(PV-L850)
You can watch TV when the Camcorder is
attached to the TV Tuner.
4
TV Tuner Jack
PHOTO
2
VCR
CAMERA
OFF
Tripod Mounting
Hole
1
TV Tuner
pack
TV Tuner Cable
TV Tuner pack
Underside View
3
CH
CH
CH AUTO
DOWN
SET
UP
Before you begin...
Connect Palmcorder to power source.
Insert recorded tape.
Set POWER to VCR.
Quick Visual Search
Search Speed
SP (Standard Play)
: 3 times normal.
SLP (Super Long Play) : 9 times normal.
During playback, press:
FF
: fast forward search
REW : rewind search
Press again or press PLAY for normal
play.
Still Picture
Press STILL to freeze picture.
Press again for normal play.
Auto Tracking
Continuously analyzes each recording for
optimum picture quality.
Manual Tracking
Some recordings require manual
adjustment to reduce noise.
In Playback mode:
Press UP
or DOWN
until Playback
picture clears up.
Press DISPLAY to return to Auto Tracking.
In Still mode:
Press UP
or DOWN
until Still picture
clears up.
Press DISPLAY to return to Auto Tracking.
V-Lock Control
Reduces jitter in Still mode.
Hold down DISPLAY and UP
DOWN
until picture is stable.
Before you begin...
• Connect Camcorder to power source.
1
Attach the TV Tuner pack to the
Tripod Mounting Hole on the
underside of the Camcorder and fix
by turning the Knob.
2
Connect the TV Tuner cable to the
Camcorder TV Tuner jack.
3
Press LCD-OPEN and swing LCD
monitor fully open. Adjust viewing
angle.
4
Set POWER to VCR.
This message appears for about 2
seconds.
CH AUTO SET KEY
12:00:00AM
JAN 1 2000
5
Hold down CH AUTO SET for more
than 1 second to preset receivable
channels.
(Takes approx. 30 seconds.)
6
Press CH UP or CH DOWN to select
one channel at a time.
5
6
,
TV Playback or Viewing
Connect Camcorder to a TV to view
playback or recordings in progress.
TV with AUDIO/VIDEO IN Jacks.
TV
To Audio In
Audio/Video
Cable
(Supplied)
TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
RF Adaptor
optional
CH 3/4 Selector
TV/VCR
Selector
VHF Connecting
Cable
To VHF Antenna
Terminal
or
7
V C R - M O D E
PLEASE PUSH
Before you begin...
Connect Camcorder to power source.
Make all TV-Camcorder connections.
1
Set POWER to:
VCR
CAMERA
2
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
To Video In
3
Begin playback or recording.
To Audio/Video Out
If TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional). Tune TV to CH 3
or 4 to match RF Adaptor CH 3/4
Selector. Set Adaptor's TV/VCR
Selector to VCR for playback.
To watch TV only,
a
Set Camcorder POWER to OFF.
b
Set RF Adaptor TV/VCR Selector to TV.
c
Turn TV ON and select channel.
VHF Antenna
300 ohm-75 ohm
transformer
or F Connector
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
UHF Antenna
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Back of TV
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
VHF
UHF
7
While TV Tuner screen is displayed,
Press:
STILL
DEL
PLAY
REW
FF
+
STOP
Slide:
8
To resume normal Camcorder
operation.
Note:
TV programs cannot be recorded.
TV Tuner dose not work alone.
There is no extenal ANT. INPUT jack.
Channel preset is not memorized.
TV Tuner cannot be use with built-in DC
Light due to power consumption.
Power consumption is 2 W(approx.60 min.
operation with PV-BP18).
Can operate with an AC adapter or optional
Car Battery Cord.
If the TV Tuner is used in a moving vehicle,
the picture may become distorted.
view playback.
view picture as it is
recorded.
PLAY:
TV Tuner screen
disappears, playback
begins.
Press STOP to return to
TV Tuner screen.
FF/REW: TV Tuner screen remains
during FF/REW.
VOLUME: Adjust volume of speaker,
or earphone if connected.
VOLUME indication will
not appear in LCD monitor.
Press
: Volume up(+).
Press W : Volume down(-).
EJECT:
TV Tuner screen remains
during eject. Audio is
muted.
Remove TV Tuner pack or Tuner
cable
Set Camcorder POWER to OFF or
CAMERA or PHOTO.
Warning messages, like WARNING
LOW BATTERY or WARNING
DEW DETECTED will only appear
on the normal screen and not on the
TV Tuner screen.
Advertisement
