Advertisement
Alignment Tape.
Equipment Required:
Dual Trace Oscilloscope
VHS-C Alignment Tape (VFMS0004H6C)
VHS-C Alignment Tape (VFMW0001C)
Screwdriver Set (Purchase Locally)
TP Board Kit
TP Adjustment Cable 40P (LSUP0005A)
TP Adjustment P.C.B. 40P (VFKW0123B)
TP Clip 36P (LSUP0005C)
7.2.2.2. ENVELOPE OUTPUT ADJUSTMENT
The height of the S and T Posts replacement part is preset at the factory.
Purpose:
To achieve a satisfactory picture and secure precise tracking.
Symptom of Misadjustment:
If the envelope is output poorly, much noise will appear in the
picture. Then the tracking will lose precision and the playback
picture will be distorted by any slight variation of the tracking
control circuit.
1. Put the unit into the service mode "I. Tracking Fix" to defeat Auto
Tracking. Refer to
DIAGNOSTIC
2. Connect the oscilloscope to Pin 30 (Envelope signal) on the TP
Adjustment P.C.B. Use Pin 33 (Head Switch signal) as a trigger.
3. Play back the Alignment Tape (VFMS0004H6C).
4. Confirm that the RF envelope is flat enough. If not, with Flat
Headed (—) Screwdriver, adjust S and T post height so that the
envelope waveform becomes as flat as possible (No envelope
drop). If the envelope drop appears on the left-half of the
"SERVICE MODE SPECIFICATION (SELF-
SYSTEM)" in "SERVICE NOTES."
Fig. M2-2
83
Advertisement
