Advertisement
twisting action. The leadless component is attached to the PCB
with glue. So carefully twist the component when removing it so
as not to break or damage any fail under the component.
B. Take care not to break the copper foil on the printed board.
3. Installation of the leadless component
A. Presolder the contact points of the circuit board.
B. Press the part downward with tweezers and solder both
electrodes as shown below.
Note:
Do not glue the replacement leadless component to the circuit
board.
5.1.13. SPECIAL NOTE
All integrated circuits and many other semiconductor devices are electrostatically sensitive and
therefore require the special handlings techniques described under the "ELECTROSTATICALLY
SENSITIVE (ES) DEVICES" section of this service manual.
5.1.14. MODEL NO. IDENTIFICATION MARK
Use Marks shown in the chart below to distinguish the different models included in this Service
Manual.
Fig. 6-1
Fig. 6-2
Fig. 6-3
26
Advertisement
