Advertisement
C. Select the H. Safety Defeat in SERVICE MODE. Refer to "
SERVICE MODE SPECIFICATION (SELF-DIAGNOSTIC
"
Or, connect a silicon diode on component side of the Main
C.B.A. as shown to defeat safety function.
(Since Takeup Reel sensor, located on Main C.B.A. does not
work when opening Main C.B.A., the mechanism does not work
(Reel lock). Therefore, make sure to defeat Safety function.)
2. Use extreme care so as not to apply any excessive pressure to
the Cylinder/Head Amp F.P.C. After servicing, be sure to place it
correctly. Refer to
3. The LCD open/close SW. is for changing between LCD Display or
EVF Display. When turning on LCD Display, place some paper or
tape, etc. on LCD open/close SW. so that this SW. stays ON.
4. Use a grounded ESD wrist strap while disassembling the Lens
portion.
5. Use extreme care when unplugging or plugging in connectors.
"Cylinder
Ass'y" in "MECHANISM SECTION."
Fig. 1-1
6
SYSTEM).
Advertisement
