Compaq PROLIANT ML370 Maintenance And Service Manual page 73

Table 3-2
POST Error Messages
continued
Error Code
1778 - Slot x Drive
Array resuming
Automatic Data
Recovery process
1779 - Slot x Drive
Array—replacement
drives detected OR
previously failed
drive(s) now appear
to be operational:
Port (y): SCSI ID (x):
Restore data from
backup if
replacement drive x
has been installed.
1780 - Disk 0 Failure
1781 - Disk 1 Failure
1782 - Disk
Controller Failure
1783 - Slot x Drive
Array Controller
Failure
1784 - Slot x Drive
Array Drive Failure.
The following SCSI
drive(s) should be
replaced: SCSI
port (y) SCSI ID (x).
Audible Beeps Probable Source of Problem
None This message appears whenever
a controller reset or power cycle
occurs while Automatic Data
Recovery is in progress.
None Intermittent drive failure and/or
possible loss of data
None Hard drive/format error
None Hard drive/format error
None Hard disk drive circuitry error
None ROM installation problem or
Array Accelerator board problem
None Defective drive and/or cables
Diagnostics and Troubleshooting 3-19
Recommended Action
No action required. This
message appears whenever a
controller reset or power cycle
occurs while Automatic Data
Recovery is in progress.
If this message appears and
drive x (identified by its SCSI ID)
has not been replaced, this
indicates an intermittent drive
failure. This message also
appears once immediately
following drive replacement
whenever data must be restored
from backup.
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
If this message appears
immediately following a ROM
installation, the ROM is
defective or not installed
properly. Check that the
controller is firmly inserted in its
slot. Try upgrading the System
ROMs. Otherwise, replace the
Integrated Smart Array
Controller.
Check for loose cables. Replace
defective drive x and/or
cable(s).
continued