Post Error Messages - Compaq PROLIANT ML370 Maintenance And Service Manual

3-8 Compaq ProLiant ML370 Maintenance and Service Guide
Error Code
A Critical Error
occurred prior to this
power-up
Unsupported
Processor Detected
System Halted
FATAL ROM ERROR:
The System ROM is
not properly
programmed
101 - ROM Error
101 - I/O ROM Error
102 - System Board
Failure
104 - ASR-2 Timer
Failure
105 - Current System
ROM is corrupt—
now booting
redundant System
ROM
162 - System
Options Not Set
163—Time & Date
Not Set
164 - Memory Size
Error
172 - Configuration
Nonvolatile Memory
Invalid
173 - Slot ID
Mismatch
174 - Configuration/
Slot Mismatch Device
Not Found
Table 3-2

POST Error Messages

Audible Beeps Probable Source of Problem
None A catastrophic system error,
which caused the server to
crash, has been logged.
1 long, 1 short Processor not supported by
current system ROM
1 long, 1 short ROM programmed in factory
incorrectly
1 long, 1 short System ROM checksum
None Options ROM checksum
None DMA, timers, and so on
None System board failure
2L Non-booted ROM image is
corrupt
2S Configuration incorrect
2S Invalid time or date in
configuration memory
2S Configuration memory incorrect
None Nonvolatile configuration corrupt
or jumper installed
None Board replaced, configuration not
updated
None PCI board not found
Recommended Action
Run Diagnostics. Replace failed
assembly as indicated.
Check documentation for
supported processors, and if
supported, remove the
processor and update the
system to latest ROM.
Replace the physical ROM part.
Run Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace failed
assembly as indicated.
Replace the system board. Run
the Compaq System
Configuration Utility.
Run Diagnostics. Replace failed
assembly as indicated.
Flash the ROM utilizing
ROMPaq.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
continued