Compaq PROLIANT ML370 Maintenance And Service Manual page 109

The following ASR-2 flow chart shows you the sequence of events after a hardware or software
error occurs:
Unattended server starts the
Operating System.
If the server continues experiencing
hardware/software errors and the
number of ASR cycles exceed the
specified number of recovery
attempts, the server logs an error to
the Server Health Log or the
Integrated Management Log and
starts the Compaq Utilities from the
Compaq system partition on the hard
drive.
Figure 3-1. ASR-2 flow chart
Hardware/Software error occurs
Error is recorded in the Compaq
system partition or the Integrated
Management Log, depending on the
server configuration.
Operating system halts normal
operation.
ASR timer expires.
Server is reset.
If a modem is installed and paging is
enabled, the Server Failure
Notification pager alert is sent to the
Server Administrator.
|
---Or---

Diagnostics and Troubleshooting 3-55
|
|
|
|
|
Server starts the Compaq Utilities
on the Compaq system partition on
the hard drive
If a modem is installed, ASR puts
the modem on auto answer so that
the Server Administrator can dial in
(using third party terminal emulator
software) to remotely run the
Compaq Utilities to identify the
source of the fault.
Local server administrator runs
Compaq Utilities from server
console to identify the source of
the fault.
|
|
Or
|