Polaris 850 PRO-RMK 155 2020 Manual page 303

e
9. Install the recoil washer
t
recoil return spring from the reel.
10. Install the recoil friction spring
u
.
11. Verify the recoil return spring tang fits in the hole in
the housing, while the other tang fits in the notch on
the ratchet.
12. Verify the recoil friction spring tang fits in the notch on
the ratchet.
i
13. Install the friction plate .
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
r
, recoil spacer , and
y
and recoil ratchet
ENGINE / COOLING / EXHAUST
o
14. Install washer and fastener
specification.
NOTICE
Apply Loctite® 242™ to fastener prior to installation.
TORQUE
Recoil Friction Plate Fastener:
15 ft-lbs (20 N·m)
15. Pull rope out to its full extension and align pulley
notch with rope hole in housing.
16. Using a needle nose pliers or hooked wire, pull a loop
of rope through the notch in the reel.
17. Prevent the rope from being retracted by tying a knot
in the rope on the outside of the housing at the rope
guide hole.
18. Wind the recoil pulley counterclockwise until the
spring begins to bind. Unwind the pulley clockwise
two revolutions.
19. Pull on the rope to disengage it from the notch in the
pulley. Untie the knot in the rope and allow it to retract
into the housing.
a
. Torque fastener to
3
3.103