Removing/Installing The Seat Assembly (Tdx Sp With Elevating Seat); Removing; Installing - Invacare Formula CG Tilt User Manual

3. Disconnect the elevator actuator form the actuator controller
connector.
The elevator actuator is marked with a tag reading
"Elevate".
The elevator actuator is marked with a tag reading
"Elevate".
CAUTION!
– Connect the external power source ONLY to
the elevate actuator connector. Connecting the
external power source to the actuator controller
connector will damage the controller
4. Connect the external power source to the elevate actuator
connector.
7.33 Removing/Installing the Seat Assembly
(TDX SP with Elevating Seat)
It is strongly recommended that two assistants lift the seat
assembly when performing this procedure.
1143155-R-01

7.33.1 Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the
Joystick.
2. Remove the seat cushion.
3. Remove the two socket screws securing the seat pan to the
seat frame.
4. Remove the seat pan from the seat frame.
5. Remove the four mounting bolts A and locknuts B securing the
seat assembly C to the actuator post D.
6. Remove the seat assembly from the actuator post and set aside.

7.33.2 Installing

Position the seat assembly C onto the actuator post D.
1.
Using four mounting bolts A and locknuts B, secure the seat
2.
assembly to the actuator post. Securely tighten.
3. Position the seat pan onto the seat frame as shown.
Setup/Maintenance
77