Mode Button; Cmpj+ Joystick, Switches And Indicators; On/Off - Drive Select Toggle Switch; Speed Control - Invacare FDX User Manual

5.4.8 Mode Button

The mode button H is only present on SPJ+ w/ACC joystick

5.5 CMPJ+ Joystick, Switches and Indicators

5.5.1 On/Off - Drive Select Toggle Switch

The drive select toggle switch A is located on the left side, below
the LCD. The drive select position is momentary, meaning that it will
return to the neutral position after a selection is made.
This switch allows the operator to select the type of operation
or performance which best suits a particular control need or
situation. The DRIVE 1 program uses performance values which are
independent of those used for the DRIVE 2 or 3 or 4 program. As an
example, an operator may have a control need for spasticity in the
morning and a very different need in the afternoon. DRIVE 1 can be
programmed for higher speeds and quicker response while DRIVE
2 can be programmed for slower speeds and less responsiveness
or vise versa. The other two drive programs could be indoor and
outdoor versions of DRIVE 1 and DRIVE 2.
Selecting the Drive Mode
1. Move the toggle up and release. DRIVE 1 will appear on LCD.
2. Move the toggle up and release again. DRIVE 2 will appear on
LCD.
3. Move the toggle up and release again. DRIVE 3 will appear on
LCD.
4. Move the toggle up and release again. DRIVE 4 will appear on
LCD.
5. Move the toggle up and release one more time to select DRIVE 1.

5.5.2 Speed Control

The speed control knob B is located on the side of the joystick
housing.
1163181-F~00
1. Rotate the knob clockwise (forward) to increase the speed of
the wheelchair to the programmed max speed.
2. Rotate the knob counterclockwise (backward) to decrease the
speed of the wheelchair to the programmed max speed.

5.5.3 Joystick

The joystick C has proportional drive control, meaning that the
further the joystick is pushed from the upright (neutral) position, the
faster the wheelchair or seat moves. Your top speed, however, is
limited by the programmed settings.
To slow the wheelchair to a stop, simply release the joystick. The
wheelchair has automatic speed and direction compensation to
minimize corrections.

5.5.4 Charger/Programming Input

The charger/programming input D is located at the front of
the joystick housing. This provides easy access for charging
the wheelchair batteries. This port also serves as the Remote
Programmer Communication connection. Driving is prevented while
the system is charging.
Wheelchair Operation
41