Chapter 7. DTE Port Configuration
PPP Synchronous Protocol (PPP SYNC)
PPP S
frame relay network and also routes IP traffic from the network to
the PPP device. See Figure 7-8 for the PPP S
tree.
Routing
Routing tables are formed through a combination of RIP and static
route entries. If RIP is used, routing tables are generated
dynamically. With static routing, the user is able to force
relationships. Static routing requires additional configuration (see
the chapter IP Setup on page 12-1 for more information).
A port set for PPP S
traffic only.
7-16
protocol provides a PPP device access to the
YNCHRONOUS
YNCHRONOUS
PROTOCOL
PHYSICAL LAYER OPTIONS INTERFACE TYPE
PROTOCOL OPTIONS
ADDRESS TABLE
Figure 7-8. PPP Synchronous Protocol Menu Tree
Express 5210 User Manual
YNCHRONOUS
protocol routes and supports IP
PPP SYNCHRONOUS
BIT RATE (selections depend on
TD CLOCK SOURCE
TRANSMIT IDLE CODE
HARDWARE FLOW CONTROL
N/A
N/A
menu
EIA 232
V.35
N
speed setting)
ETWORK
INTERNAL
EXTERNAL
FLAGS
ONES
OFF
ON
61200208L1-1